+高级检索
小口径非球面透镜模压成形加热和加压参数的仿真研究
DOI:
作者:
作者单位:

作者简介:

通讯作者:

基金项目:

国家自然科学基金项目(50975804);国家自科基金中澳合作基金项目(50811120105)


Investigation on the Heating and Pressing Parameters of Micro Aspheric Lens Molding Process by Simulation
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    建立了非球面透镜模压模型,设置了相应的边界条件,利用有限元仿真软件对小口径非球面透镜模压成形加热﹑加压过程进行了数值计算,得到了模压后玻璃残余应力分布和应变分布,确定了该材质玻璃的最优模压温度和最短加热时间,并得到了模压温度与最大残余应力、加压速率与平均残余应力的关系。

    Abstract:

    In this paper, a model of aspheric lens molding process was established and all the boundary conditions were set. Through the finite element software, the heating and pressing processes were simulated and the glass residual stress distribution and strain distribution after pressing process were studied. Finally, the optimum molding temperature and the minimum heating time for the D-ZK3 glass were predicted. The relationship between molding temperature and maximum residual stress, molding velocity and average residual stress were all clarified.

    参考文献
    相似文献
    引证文献
文章指标
  • PDF下载次数:
  • HTML阅读次数:
  • 摘要点击次数:
  • 引用次数:
引用本文

霍建杰.小口径非球面透镜模压成形加热和加压参数的仿真研究[J].湖南大学学报:自然科学版,,():

复制
历史
  • 收稿日期: 2010-06-01
  • 最后修改日期: 2010-08-31
  • 录用日期: 2010-11-12
  • 在线发布日期: 2011-03-04
  • 出版日期:
作者稿件一经被我刊录用,如无特别声明,即视作同意授予我刊论文整体的全部复制传播的权利,包括但不限于复制权、发行权、信息网络传播权、广播权、表演权、翻译权、汇编权、改编权等著作使用权转让给我刊,我刊有权根据工作需要,允许合作的数据库、新媒体平台及其他数字平台进行数字传播和国际传播等。特此声明。
关闭