+高级检索
高强螺栓承压型连接抗剪承载力计算
DOI:
作者:
作者单位:

作者简介:

通讯作者:

基金项目:


Study on Shear Capacity of High-strength Bolted Bearing-type Joint
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    针对现行规范在计算高强度螺栓承压型连接的抗剪承载力时不考虑连接板之间的摩擦力,与承压型高强螺栓的受力机理不相符的问题,采用虚功原理推导了预拉力模拟方法,并采用有限元方法对这一连接的受力过程进行分析.分析结果表明,当连接的承载力由螺栓强度控制时,若不考虑构件间的摩擦力, 则高强螺栓承压型连接的承载力会被低估.在数值分析的基础上对这种连接方式的抗剪承载力提出了考虑连接板间摩擦力的计算方法.与有限元结果比较,该计算方法的误差在10%以内.

    Abstract:

    The friction forces between connecting plates are not taken into account in the shear capacity calculation of high-strength bolted bearing-type joints in the current Codes, which is not consistent with the bearing mechanism of high strength bolts.The principle of virtual work was adopted to go through pre-stress simulation method, and the finite element method was adopted to analyze the loading process of bearing-type joints.The results show that, without considering the friction forces between connecting plates, when the bearing capacity of connection is controlled by bolt strength, the shear capacity of high-strength bolted bearing-type joints will be underestimated.In this paper, based on numerical simulation, a reasonable method considering friction forces between connecting plates was proposed to calculate shear capacity of high-strength bolted bearing-type joints.Compared with FEM results, the error of new method is less than 10%.

    参考文献
    相似文献
    引证文献
文章指标
  • PDF下载次数:
  • HTML阅读次数:
  • 摘要点击次数:
  • 引用次数:
引用本文

杜运兴 ,欧阳卿.高强螺栓承压型连接抗剪承载力计算[J].湖南大学学报:自然科学版,2013,40(3):21~25

复制
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期:
  • 出版日期:
作者稿件一经被我刊录用,如无特别声明,即视作同意授予我刊论文整体的全部复制传播的权利,包括但不限于复制权、发行权、信息网络传播权、广播权、表演权、翻译权、汇编权、改编权等著作使用权转让给我刊,我刊有权根据工作需要,允许合作的数据库、新媒体平台及其他数字平台进行数字传播和国际传播等。特此声明。
关闭