+高级检索
应用于眼压信号检测的低噪声前置放大器设计
DOI:
作者:
作者单位:

作者简介:

通讯作者:

基金项目:


Design of Low-noise Preamplifier for Application of IntraocularPressure Signal-detection
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    基于SMIC 180 nm CMOS工艺,设计并实现了一款应用于眼压信号检测系统的低噪声前置放大器.该放大器使用二极管连接的MOS管实现GΩ级别的大电阻,在反馈回路中该伪电阻与反馈电容并联在低频段产生高通截止点以抑制直流失调电压和低频噪声,达到较好的噪声性能.后仿真结果显示:低噪声前置放大器的直流增益为40 dB,有效带宽从0.25 Hz到46 kHz,在低频频率100 Hz处的等效输入噪声为197.3 nVrms,采用1.8 V的电压供电,核心电路功耗为32.4 μW,芯片面积为0.75 mm×0.62 mm.

    Abstract:

    A low-noise preamplifier applied to the intraocular pressure signal-detection system with 180 nm CMOS process was proposed.The amplifier adopts a diode-connected MOS transistor to achieve a large resistance of GΩ level.In the feedback loop,the pseudo-resistor and the feedback capacitor are connected in parallel to generate a high-pass cutoff point in the low frequency,which can suppress the DC-offset voltage and the noise in low frequency to achieve better noise performance.The post-simulation results show that the low noise preamplifier has a DC-gain of 40 dB,the effective bandwidth is from 0.25 Hz to 46 kHz,and an equivalent input noise is 197.3 nVrms at 100 Hz.The power consumption of the core circuit is 32.4 μW at a supply of 1.8 V,and the chip area is 0.75 mm×0.62 mm.

    参考文献
    相似文献
    引证文献
文章指标
  • PDF下载次数:
  • HTML阅读次数:
  • 摘要点击次数:
  • 引用次数:
引用本文

曾健平,樊明,陈铖颖,张锋.应用于眼压信号检测的低噪声前置放大器设计[J].湖南大学学报:自然科学版,2017,44(8):112~116

复制
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2017-09-20
  • 出版日期:
作者稿件一经被我刊录用,如无特别声明,即视作同意授予我刊论文整体的全部复制传播的权利,包括但不限于复制权、发行权、信息网络传播权、广播权、表演权、翻译权、汇编权、改编权等著作使用权转让给我刊,我刊有权根据工作需要,允许合作的数据库、新媒体平台及其他数字平台进行数字传播和国际传播等。特此声明。
关闭