+高级检索
振荡剪切模式下磁流变脂法向力特性分析
DOI:
作者:
作者单位:

作者简介:

通讯作者:

基金项目:


Analysis of Normal Force Characteristics for Magnetorheological Grease in Oscillatory Shear Mode
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    为了探究磁流变脂的法向力行为,自制了羰基铁粉质量分数分别为30%、50%和70%的3种磁流变脂,采用旋转流变仪测量了磁流变脂在振荡剪切模式下的法向力特性,系统地研究了磁场、时间、应变幅值、频率和温度对法向力的影响. 研究结果表明,3种磁流变脂试样的法向力都随着磁场强度增大而增大,当磁场强度为740 kA/m时,各试样法向力最大值分别达到了6.97 N、8.93 N、14.91 N;在不同磁场强度下,时间对磁流变脂法向力值的影响经历轻微减少、恒定不变、缓慢增加3个阶段;在整个频率范围内,不同磁场强度的磁流变脂的法向力值变化微小,基本处于一个稳定值;存在一个应变临界值,使得法向力随着应变幅值在临界值之前以较快的速度增大,进一步增大应变幅值且超过该临界值后其增长速度减小;另外,3种磁流变脂试样的法向力随温度的升高而增大且质量分数为70%的试样其法向力值最大. 本文研究为磁流变脂器件的设计、优化和应用奠定了理论基础.

    Abstract:

    In order to investigate the normal force behavior of Magnetorheological Grease(MRG),three magnetorheological greases with carbonyl iron powder mass fractions of 30%,50% and 70% respectively were fabricated and measured by using a rotational rheometer in the mode of oscillatory shear. And the effects of magnetic field,time,strain amplitude,frequency and temperature on the normal force were systematically analyzed. The results show that the normal force values of three MRG samples increase with the increase of magnetic field strength. When the magnetic field strength is 740 kA/m,the maximum value of each sample reaches 6.97 N,8.93 N,14.91 N. Under different magnetic field levels,the influence of time on the normal force of magnetorheological grease undergoes three stages of slight decrease,constant,and slowly increasing. In the entire frequency range,the normal force value of the MRG with different magnetic field strengths changes slightly and basically at a stable value. There is a strain critical value,and the normal force increases with the strain amplitude at a faster speed before the critical value,further increases the strain amplitude and decreases the growth rate after exceeding the critical value. In addition,the normal force of the three MRG samples increases with increasing temperature and the MRG-70 normal force value is the largest. The above study of normal force in MRG is the theoretical basis for the design,optimization and application of magnetorheological grease devices.

    参考文献
    相似文献
    引证文献
文章指标
  • PDF下载次数:
  • HTML阅读次数:
  • 摘要点击次数:
  • 引用次数:
引用本文

叶绪丹,王炅,黄学功.振荡剪切模式下磁流变脂法向力特性分析[J].湖南大学学报:自然科学版,2020,47(4):49~56

复制
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2020-04-23
  • 出版日期:
作者稿件一经被我刊录用,如无特别声明,即视作同意授予我刊论文整体的全部复制传播的权利,包括但不限于复制权、发行权、信息网络传播权、广播权、表演权、翻译权、汇编权、改编权等著作使用权转让给我刊,我刊有权根据工作需要,允许合作的数据库、新媒体平台及其他数字平台进行数字传播和国际传播等。特此声明。
关闭