HUANG Shou-dao , CAI Guo-yang , GAO Jian
Abstract:集旋转与悬浮于一体的无轴承异步电机是一个非常复杂的非线性系统,电磁转矩与径向悬浮力的非线性解耦是实现电机稳定悬浮运行的基础.为了降低控制系统对电机参数的依赖程度,本文采用定子磁场定向控制,同时为了克服此方法在低速时的不足,应用U-I法和I-ω法相结合观测定子磁通和气隙磁通,在matlab/simulink中构造了定子磁场定向控制的无轴承异步电机矢量控制系统.仿真结果表明:实现了电磁转矩与径向悬浮力之间的解耦,验证了此方法的有效性.
Abstract:In the design of a pattern classifier,it is difficult or impossible to acquire all the necessary essential attributes for precise classification,so both the fuzzy uncertainty and rough uncertainty coexist in classification. A FRMFN(Fuzzy-Rough Membership
ZHANG Hong-nan , LUO Pi-jin , HUANG Ya-you , ZHANG Wei-qing , ZENG Yun
Abstract:We designed a kind of mixer for the low voltage supply circuit.The core of this mixer was a version of switched transconductor.By doing this,the reduction of the voltage induced by finite on-resistance of the switch devices was reduced to almost zero.In t
WEN Si-wei , ZENG Jing-cheng , XIAO Jia-yu , YANG Fu-biao , WANG Zun , ZHANG Chang-tian
Abstract:A method of preparing single fiber pull-out specimens was designed,and the interfacial shear strength(IFSS) of Bf/epoxy resin composites was measured by single fiber pull-out rest.The failure of the interface in single boron fiber pull-out test was analyz
XIE Yong-qin , YANG Li , QIN Gui-xiang
Abstract:This paper analyzed the mathematical model of the strain solitary waves,which were possibly formed after the Geometry dispersion effect was produced when the nonlinear elastic rod was loaded with sudden bearing pulling or pressing.We have obtained the suf
LI Wen-hua , PENG Jing-cui , HUANG Chun-jia , CHEN Xiao-hua
Abstract:采用全量子理论和数值计算方法求解了旋波近似下相干态光场与耦合双原子相互作用的系统波函数,分析了原子的初始状态和原子间偶极偶极相互作用Ω对光子统计性质的影响.数值计算结果显示:原子间偶极偶极相互作用Ω对光子的超泊松分布效应无明显影响,但崩塌-回复周期却随Ω的增大而减小,近似成反比关系;系统初始状态对光子的超泊松分布效应有明显影响,而对崩塌回复周期无影响.
CUI Kun-zai , CHEN Jin-hua , DENG Guo-hong , FAN Zhen , SUN Feng , KUANG Ya-fei
Abstract:以石墨底材上直接生长的碳纳米管为基体,采用电化学循环伏安法制备了氧化钌/碳纳米管/石墨电极,通过扫描电子显微镜考察了电极的表面形貌,并在硫酸溶液中研究了其电化学性能.结果表明:氧化钌/碳纳米管/石墨电极具有较好的超电容性能,当RuO2的载量为15.5μg.cm-2时,该复合电极的比电容为215 F.g-1,为相同条件下制备的氧化钌/石墨电极比电容的2.4倍.
LU Yan-bing , SHI Yan-cai , SUN Li-li , SUN Rong-xin , XIONG Yuan-qin , XU Wei-jian
Abstract:合成N-对羟基苯基马来酰亚胺,并将其用作固化剂固化邻甲酚醛环氧树脂.采用DSC方法研究了HPM固化邻甲酚醛环氧树脂反应的固化反应动力学.对固化产物的热分析结果表明:N-对羟基苯基马来酰亚胺是非常良好的耐热固化剂,可明显提高邻甲酚醛环氧树脂的耐热性能,固化产物的起始热分解温度为338℃,分解10%时的温度为386℃,700℃时的残留百分量为49%.
AI Qiu-hong , LUO He-an , WANG Liang-jie , YANG Yan-tao
Abstract:A reaction pathway for ammonolysis of O,O-dimethylphosphorochloridothioate without catalyst was proposed,based on the reaction mechanism of acyl halide ammonolysis,and the pseudo-homogeneous reaction kinetics were founded.The model parameters were estimat
XIE Shui-bo , CHEN Ze-ang , ZHANG Xiao-jian , HE Shao-hua , LU Jun-wen
Abstract:对宏观弥散度和阻滞系数的取值进行了理论分析,运用PHREEQCⅡ软件,以我国南方某铀水冶尾矿库为例,探讨了宏观弥散度和阻滞系数对地下水中核素迁移模拟的影响.研究表明:宏观弥散度和阻滞系数对大时空的核素迁移模拟影响显著.在其他条件相同的情况下,弥散度增大,受污染地下水中总U浓度开始降低的距离将缩短,但反而迁移得更远;随着阻滞系数的增大,同距离处234U的浓度将显著下降,但其迁移距离变短.要得到可靠的宏观弥散度和阻滞系数,可利用宏观参数与介质统计特性的关系求解介质宏观弥散参数,阻滞系数可由现场实验或实验室土柱实验直接测得.
ZHOU Li , WANG Lian-hong , LI Li-juan
Abstract:Starting with the coding feature of the XML,this paper presented a new algorithm for the digital watermarking based on XML.The display effectiveness and the length of document are not changed by the algorithm,but watermarking can not easily be detected an
Abstract:The generalized singular-value decomposition of the matrix pair A and B this a powerful tool for solving the constrained matrix equations.With the aid of the CS decomposition of the matrix pair A and B,this paper gave a new proof of the theorem of the gen
PENG Guo-qiang , HUANG Li-hong
Abstract:The exponential stability of a class of stochastic differential equations was studied by using Gronwall and generalized Gronwall inequality.Some sufficient conditions for the any p-th moment exponential stability were established.The necessary condition t
TANG Sheng-xue , HE Yi-gang , GUO Jie-rong , LI Hong-ming , HUANG Jiao-ying , YANG Hui
Abstract:提出了一种新的采用∑-△调制和无损离散积分振荡器来产生片内模拟信号的方法.研究了电路的实现原理和噪声传递函数零点优化设计方法,运用无乘法器的梯型滤波器结构和∑-△调制技术避免了多位高精度乘法运算和多位D/A数模转换器硬件成本高的缺点.除一个比较器外,整个电路全部由标准CMOS工艺来实现集成,硬件成本非常低,非常适用基于可测性混合集成电路的设计.通过一个6阶实例和仿真的结果表示:6阶的信号发生器具有120 dB衰减的动态带宽.
ZHAO Yue-yu , ZHOU Hai-bing , JIN Bo , LIU Wei-chang
Abstract:The influence of bending rigidity on the internal response of inclined cable was studied.The three dimensional nonlinear dynamical equations of the inclined cable were deduced in Hamiltonian principle,the internal response pattern of the inclined cable wa
ZENG Ling-hong , SHANG Shou-ping , DAI Rui
Abstract:This paper a proposed method for strengthening reinforced concrete beams using high-performance ferrocement laminate.The results of ten RC beams strengthened with U-shape ferrocement(ferrocement was put onto the tension face and two profile faces)and two
LI Shou-ying , CHEN Zheng-qing , HUANG Lei , ZHU Zhi-wen
Abstract:义乌游泳馆采用凹形屋盖,对这种屋盖结构的风荷载研究还比较少.为此,制作了比例为1:100的刚性模型,采用同步测压技术,进行了义乌游泳馆凹形屋盖的风压测量,得到了其屋盖上的平均风压系数分布并与凸形屋盖的试验结果进行比较.结果表明:凹形屋盖上的“吸力”要远大于凸形屋盖上的“吸力”;迎风向挑棚上、下表面压力出现不利的负相关,应引起设计人员的注意;周边建筑对义乌游泳馆屋盖风荷载的影响不大.最后还给出了义乌游泳馆屋盖上的前10个最小极值风压.
LIU Jie , ZHAO Ming-hua , HE Jie
Abstract:To explore the relations among the bearing capacity of the composite foundation with granular column,the compression value of the reinforcement area and the plastic area radius of surrounding pile soil,the bearing and deformation characters of the composi
GUO Jian , HE Yi-bin , LI Shi-ping , ZHOU Hai-bing , TIAN Yan-xin
Abstract:The real stiffness of frame in different deformation phases was determined according to experimental data,and the stiffness degradation coefficient was adopted to revise the stiffness of each floor.By using the stiffness degradation coefficients of free v
GONG Jin-ke , CAI Hao , LIU Yun-qing , FU Jun , WANG Shu-hui , LIU Qiong
Abstract:采用CAE软件对转子式机油泵内流场进行了几何建模.对模型应用非结构化网格生成技术划分网格并进行了有限元前处理.在采用k-ω湍流模型的基础上,考虑了卸荷槽的影响,应用计算流体力学软件模拟稳定工况下机油泵出口部分的三维湍流流动.得到了详尽的分析结果,包括压力等高线云图、速度矢量等高线云图等.分析并证明了卸荷槽具有缓解压力负荷的作用.完成了对机油泵的台架实验,将数值模拟得到的机油泵性能特性曲线与实验特性曲线进行比较,发现仿真结果与实验结果基本吻合.证明仿真模拟结果能够反映机油泵的流动性能和特殊流动现象;利用数值仿真可以得到具有参考意义的机油泵流量特性曲线,为机油泵开发提供了新的研究方法和技术支持.
SONG Xiao-lin , ZHANG Le-dong , YU De-jie , LI Bi-jun
Abstract:On the basis of the input and output of mcpherson-type and double-wishbone-type quarter-car models built in ADAMS,the immune algorithm was applied to identify the sprung mass,the suspension stiffness and damp,the tyre vertical stiffness and the unsprung m